Simplex APOGEE Instrukcja Użytkownika Pobierz pdf (Strona 10)

Analog Complete

The analog alignments have been listed in a logical order. Some of the adjustments are interdependent so

they may need to be repeated or perhaps re-checked. If all is well this is the time to lock down the reader

adjustments using a 5/32" allen wrench. One could also check that the socket head clamp screw holding

the analog LED in place is locked down properly.

The next step would be to set Dolby level using Dolby Cat. Number 69 T test film.

1. Set the processor optical pre-amp at 80% gain and the slit loss compensation at zero.

2. Adjust the LED current control on the analog LED power supply to achieve Dolby level.

3. Fine tune the pre-amp controls so both channels are at Dolby level.

4. If there is a significant difference in the required gain for each channel you may want to repeat the

LED alignment procedure.

5. If not................analog alignment is complete.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Brak uwag

Simplex APOGEE Instrukcja Użytkownika Strona 10